Fastalarms - 0800 4488823 installing in Yorkshire

YALE wirefree alarm installation specialist and online sales

Remote access to your YALE telecommunicating alarm

Your YALE telecommunicating alarm will contact the three telephone numbers stored in its memory in the event of the alarm being activated. You will then hear your pre recorded message. In the event of a door contact or PIR being activated you will recieve the message BURGLAR followed by your pre recorded name and address message. In the event that your alarm has been triggered by the LINKED smoke alarm (if fitted) you will receive the message EMERGENCY followed by your pre recorded details. If you are not able to answer your phone the control panel will then call the next number on your list and so on until all three numbers have been contacted.

Use these instructions if you need to access your alarm. Using these instructions you will be able to SET your alarm remotely for example if you have got to work and forgotten to set it. No need to rush back or worry. UNSET the alarm if you have visitors or workmen etc . CHECK the alarm status , Is it armed or disarmed or part armed? ACTIVATE and DEACTIVATE your siren.

 

REMOTE ACCESS INSTRUCTIONS YALE 6400 Premium alarm You will need a tone dialling handset either mobile or landline.

1 Dial the phone number associated with the Control

   Panel ( usually your home land line).

2 Hang up on the first ring.

3 Wait 5-10 seconds.

4 Dial the number again.

5 The control unit will now  answer the call you

   Will hear a beep. (If not repeat the above)

6 Enter your alarm PIN Code within 3 seconds.

7 If the PIN code is correct, you will hear another

   beep you are now connected to your alarm.

 

      Once connected the following apply

Press 2  This will arm the system

Press 3  To disarm the system.

Press 5  Check the system status. Long single

           beep for Away Armed, two beeps for

           Disarmed and three beeps for Home Armed.

Press 7 Siren on.

Press 8 Siren off.

Press 9 or 0 Disconnect.

• Remember to press 9 or 0 before you hang up, or

the control unit will hang up automatically after 30

seconds.